I found this great confetti launcher craft (just in time for the 4th of July) at MommaFindings and wanted to share it with you. We will be trying this out over the weekend. The thing I love about it, is that you can use it again and again!
Craft Idea: Confetti Launchers for 4th of July Fun
by Sara at MommaFindings
Every Summer, I write about 50 posts about how much I love 4th of July. It's one of my favorite Holidays because it brings everything I love together for one day: Family, Fun, Fireworks, and Funnel Cakes (not necessarily in that order)!
To add to my excitement, I usually plan out a few 4th of July themed crafts to do with the kids. I have memories of all kinds of face painting when I was younger and I want my children to remember this Summer Holiday as I did. For the next couple of weeks, I'll bring you all kinds of 4th of July Crafts you can enjoy with you family. What kind of fun can you have with confetti? Today, I bring you the Ultimate Confetti Launcher for Patriotic Pizazz!
4th of July Confetti Launcher
Fireworks happen only after dark, but this craft creates a pop of color any time of day. Kids pull back on the string to release a shower of tissue paper confetti, then gather it up and refill the launcher again … and again … and again.
Materials:
-
Craft knife
-
2-inch-wide cardboard mailing tube, cut to 9 inches
-
Red or blue electrical tape
-
Hammer
-
Nail
-
Rubber band
-
2 toothpicks
-
2 (15-inch-long) pieces of string
-
5/16-inch metal nut
-
Plastic from a recycled container, cut into a disk slightly smaller than the tube and with two holes punched in the center, about 1/4 inch apart
-
red or blue star stickers
-
Red, white, and blue tissue paper, cut into small squares of confetti
Instructions:
1. Using a craft knife, trim 1 inch off the tube (a parent's job). Cut a 1/2-inch section out of this piece with scissors.
2. Insert the piece into the tube, about 1 inch from the top, and secure it with electrical tape.
3. Measure down 1-1/2 inches from the same end of the tube and make a hole with the hammer and nail. Rotate the nail to enlarge the hole. Make a second hole on the opposite side.
4. Push the rubber band halfway through one of the holes. Insert a toothpick through the outer rubber band loop, then secure it with electrical tape as shown. Tie both strings to the nut. Thread the rubber band through the nut, then push the rubber band through the second hole. Secure it with a toothpick and tape.
5. Thread the disk onto one string until it's 6 inches from the nut, then knot the string and trim any excess. Pull the other string out the bottom of the tube and knot it. The assembled launcher will look like the diagram. Decorate the tube with electrical tape and star stickers.
6. To load the launcher, rest the disk on top of the inner cardboard ring and fill this end of the tube with confetti. To launch, have your child hold the launcher firmly, pull the bottom string, then quickly release it. The nut will hit the plastic, sending the confetti sky-high and making a popping sound.
This craft can be found at Disney Family Fun Online, complete with pictures of each step.
MommaFindings has lots of great reviews and ideas.
Cammie Moise